Chapter 3 Connection, Wiring, And Attaching - Hitachi REMOTE OPERATOR WOP Instruction Manual

Chapter 3 Connection, wiring, and attaching

Before install the operator on the control panel, please fix with M3 screws from the back of
the control panel. (2 holes, the same measurement as figure 4, has to be made at first )
When connecting to the inverter, please use cable which is recommended. Otherwise, please
use the cable with appointed dimension.
Punched hole diagram
for installation
Make sure to use a straight cable within 3m in length and 10BASE-T category 5 (CAT5) of
UTP or STP when the cable is prepared by the customer.
(NOTE) UTP（Unshielded twist pair cable）, STP（Shielded twist pair cable）.
Chapter 3 Connection, wiring, and attaching
Fig. 4 Diagram for punched holes' dimensions
Tab. 7 Recommended cable
Model
ICS-1
ICS-3
2-M3 (Back side of WOP) Depth3.5mm
Content
1m cable
3m cable
9