AEG BSK892330M User Manual page 10

10 www.aeg.com
5.2 First Connection
You have to set the language, the
Display Brightness, Water hardness and
the Time of Day.
Preheat the empty oven before the first use.
Step 1
Step 2
Step 3
The oven can emit an odour and smoke during preheating. Make sure that the room is
ventilated.
5.4 How to set: Water
hardness
When you connect the oven to the mains
you have to set the water hardness level.
Step 1
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later
than 1 min after test.
You can change the water hardness level in the menu: Basic settings / Setup / Water
hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium
deposit and the water classification. Adjust the water hardness level according to the
table.
Remove all accessories and removable shelf supports from the oven.
Set the maximum temperature for the function:
Let the oven operate for 1 h.
Set the maximum temperature for the function:
Let the oven operate for 15 min.
Step 2
Shake the test paper
to remove the excess
of water.
5.3 Initial preheating
.
.
Use the test paper supplied with the
steam set.
Step 3
After 1 min, check
water hardness with
the table below.
Step 4
Set the water hard‐
ness level in the
menu: Basic settings.