Cisco 7800 Series Administration Manual page 52

Network Configuration Fields
Table 9: Ethernet Configuration Submenu
Field Field Type
or Choices
802.1x Device
authentication authentication
Transaction status
Switch port config Auto
10MB half
10MB full
100MB half
100MB full
1000 full (except for
7811 and 7821)
PC port config Auto
10MB half
10MB full
100 MB half
100MB full
100 half
1000 full (except for
7811 and 7821)
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
38
Default Description
Off Enables you to turn on or turn off the 802.1x authentication. Valid
options are:
• On
• Off
Disabled • Transaction status—Indicates different authentication status
when you turn on 802.1x in the Device authentication field.
• Protocol—Specifies the protocol of the server.
Auto Select speed and duplex of the network port.
If the phone is connected to a switch, configure the port on the
switch to the same speed/duplex as the phone, or configure both
to autonegotiate.
If you change the setting of this option, you must change the PC
Port config option to the same setting.
Auto Select Speed and duplex of the Computer (access) port.
If the phone is connected to a switch, configure the port on the
switch to the same speed/duplex as the phone, or configure both
to autonegotiate.
If you change the setting of this option, you must change the
Switch Port config option to the same setting.
• Disabled—Default status.
• Connecting—802.1x authentication started in the
device.
• Authenticated—802.1x authentication established in
the device.
Cisco IP Phone Installation