Cisco 7800 Series Administration Manual page 307

Cisco IP Phone Troubleshooting
Parameter
Codec Negotiation
Encryption Method
Dial Plan
Parameter
Dial Plan
Caller ID Map
Enable URI Dialing
Emergency Number
Description
When set to Default, the Cisco IP phone responds to
an Invite with a 200 OK response advertising the
preferred codec only. When set to List All, the Cisco
IP phone responds listing all the codecs that the phone
supports. The default value is Default, or to respond
with the preferred codec only.
Encryption method to be used during secured call.
Options are AES 128 and AES 256 GCM
Default: 128.
Description
Dial plan script for the selected extension.
The dial plan syntax allows the designation of three
parameters for use with a specific gateway:
• uid – The authentication user-id
• pwd – The authentication password
• nat – If this parameter is present, use NAT
mapping.
Separate each parameter with a semi-colon (;).
Inbound caller ID numbers can be mapped to a
different string. For example, a number that begins
with +44xxxxxx can be mapped to 0xxxxxx. This
feature has the same syntax as the Dial Plan parameter.
With this parameter, you can specify how to map a
caller ID number for display on screen and recorded
into call logs.
Enables or disables URI dialing.
Enter a comma-separated list of emergency numbers.
When one of these numbers is dialed, the unit disables
processing of CONF, HOLD, and other similar
softkeys or buttons to avoid accidentally putting the
current call on hold. The phone also disables hook
flash event handling.
Only the far end can terminate an emergency call. The
phone is restored to normalcy after the call is
terminated and the receiver is back on-hook.
Maximum number length is 63 characters. Defaults
to blank (no emergency number).
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
Dial Plan
293