Restore - Cisco ONS 15501 User Manual

Chapter 4 Command Reference

restore

To restore the system and network settings of the control module, including all passwords, to the
manufacturer's default settings, use the restore command.
Syntax Description
This command has no other arguments or keywords.
Defaults None
Command Types Changes configuration
Command Modes
No password is required.
Command History Release
EDFA 1.0
Usage Guidelines
This command can be used only from a serial port, not in a Telnet session.
Once connected to the serial port, the user must press the Enter key within 15 seconds after the password
prompt appears.
The command resets the user password to edfa, and the master password to edfa1.
The command does not reset any of the module settings; resetmeantrig must be used for that purpose.
The user is recommended to reboot the system after utilizing this command; the default settings are not
activated until the system is rebooted.
78-14134-01, Release 1.0
restore
Modification
This command was introduced.
Cisco ONS 15501 User Guide
restore
4-35