Ethmode - Cisco ONS 15501 User Manual

ethmode

ethmode
To display or modify the Ethernet boot mode, use the ethmode command.
Syntax Description
mode
Defaults
Displays the current Ethernet boot mode.
Command Types Changes configuration
Command Modes Master password protected
Command History Release
EDFA 1.0
Usage Guidelines
The system default Ethernet boot mode is 3 for full-duplex 10 Mbps.
After setting a new Ethernet boot mode, the system must be rebooted to effect the change.
Examples The following example shows how to display the Ethernet boot mode.
edfa > ethmode
ethernet init-mode 4
The following example shows how to modify the Ethernet boot mode.
edfa > ethmode 3
ethernet init-mode updated to 3
Cisco ONS 15501 User Guide
4-8
ethmode mode
Modification
This command was introduced.
Specifies the Ethernet boot mode. The boot mode is specified as 0
for auto-sense; 1 for full-duplex 100 Mbps; 2 for half-duplex 100
Mbps; 3 for full-duplex 10 Mbps; or 4 for half-duplex 10 Mbps.
Chapter 4 Command Reference
78-14134-01, Release 1.0