Scanning; Programming Scan Memory; Selecting Scan Type - Standard Horizon HX210 Owner's Manual

7.9 SCANNING

The HX210 provides two types of scanning, "Memory Scan" or "Priority
Scan". "Memory Scan" scans the channels that were programmed into Scan
Memory and also channels stored in the Preset Channel. "Priority Scan" is
similar to the "Memory Scan" scan, however it scans the priority channel
(channel 16) and dual watches to channels programmed in memory scan
and preset channel memory. When an incoming signal is detected on one of
the channels during scan, the radio will pause on that channel, allowing you
to listen to the incoming transmission.

7.9.1 PROGRAMMING SCAN MEMORY

1. Press and hold the [MENU/SET] key.
2. Press the [▲]/[▼] key to select "CHANNEL SETUP".
3. Press the [SELECT] soft key, then press the [▲]/[▼] key to select "SCAN
MEMORY".
4. Press the [SELECT] soft key.
5. Press the [▲]/[▼] key to select a desired
channel to be scanned, then press the
[MEM] soft key. The "ON" icon will appear at
the right side of the selected channel.
6. Repeat step 5 for all the desired channels to be scanned.
7. To REMOVE a channel from the list, select the channel then press the
[MEM] soft key. The "ON" icon of the selected channel will disappear.
8. When you have completed your selection, press the [CLR/
turn to radio operation.
To check channels to be scanned, press the [▲]/[▼] key repeatedly, to dis-
play each channel. The "MEM" icon will appear when a designated memory
channel is displayed.

7.9.2 SELECTING SCAN TYPE

1. Press and hold the [MENU/SET] key.
2. Press the [▲]/[▼] key to select "CHANNEL SETUP".
3. Press the [SELECT] soft key, then select "SCAN TYPE" with the [▲]/[▼] key.
4. Press the [SELECT] soft key.
5. Press the [▲]/[▼] key to select "M-SCAN"
or "P-SCAN".
6. Press the [ENTER] soft key to store the selected setting.
7. Press the [CLR/
Page 22
] key to return to radio operation.
] key to re-
HX210