Scanning - Standard Horizon QUANTUM AIS GX6000 Owner's Manual

8.10

SCANNING

The GX6000 will automatically scan channels programmed into the preset
channel memory and also the scan channel memory, and the last selected
weather channel.
When an incoming signal is detected on one of the channels during scan, the
radio will pause on that channel, allowing you to listen to the incoming transmis-
sion. The radio will automatically start scanning again after the transmission
stops.
8.10.1 Selecting the Scan Type
[ ]  "SETUP"  "CHANNEL SETUP"  "SCAN TYPE"
1.
2. Rotate the DIAL/ENT knob to select "PRIORITY" or
"MEMORY".
3. Press the [ENTER] soft key to store the selected
setting.
4. Press the [CLEAR] key to return to radio operation.
CH88
CH1078
CH68
CH1061
Memory Scan ( M-SCAN )
8.10.2 Programming Scan Memory
[ ]  "SETUP"  "CHANNEL SETUP"  "SCAN MEMORY"
1.
2. Rotate the DIAL/ENT knob to select a desired chan-
nel to be scanned, then press the [MEM] soft keys.
"ON" icon will appear at the right side of the selected
channel.
3. Repeat step 2 for all the desired channels to be scanned.
4. To REMOVE a channel from the list, select the channel then press the
[MEM] soft key. "ON" icon of the selected channel will disappear.
5. When you have completed your selection, press the CLEAR key to return
to radio operation.
38
CH1001
CH09
CH12
CH15
CH1018
CH1022
CH1001
CH88
CH1078
Priority Channel
CH68
CH1061
CH1022
Priority Scan ( P-SCAN )
CH09
CH12
CH15
CH1018