Scan Resume; Multi Watch; Priority Ch; Sub Ch - Standard Horizon HX210 Owner's Manual

SCAN RESUME

This selection is used to select the time the HX210 waits after a transmission
ends before the radio starts to scan channels again. The default setting is 2
seconds.
1. Press and hold the [MENU/SET] key.
2. Press the [▲]/[▼] key to select "CHANNEL SETUP", then press the [SE-
LECT] soft key.
3. Select "SCAN RESUME" with the [▲]/[▼] key, then press the [SELECT]
soft key.
4. Press the [▲]/[▼] key to select the desired
time. The resume time can be set to "1 sec"
through "5 sec".
5. Press the [ENTER] soft key to store the new
setting.
6. Press the [CLR/

MULTI WATCH

This selection is used to choose between "Dual Watch" and "Triple Watch".
Refer to section "7.10.1 Setting up the Multi Watch Operation" for details.

PRIORITY CH

This procedure may be used to designate a different priority channel when
priority scanning. By default, the radio priority channel is set to Channel 16.
1. Press and hold the [MENU/SET] key.
2. Press the [▲]/[▼] key to select "CHANNEL SETUP", then press the [SE-
LECT] soft key.
3. Select "PRIORITY CH" with the [▲]/[▼] key, then press the [SELECT]
soft key.
4. Press the [▲]/[▼] key to select the desired
channel to be a priority.
5. Press the [ENTER] soft key to store the new
setting.
6. Press the [CLR/

SUB CH

By default the sub channel is set to Channel 9. This procedure allows the ra-
dio to assign a different sub channel for instant access.
1. Press and hold the [MENU/SET] key.
2. Press the [▲]/[▼] key to select "CHANNEL SETUP", then press the [SE-
LECT] soft key.
3. Select "SUB CH" with the [▲]/[▼] key, then press the [SELECT] soft key.
HX210
] key to return to radio operation.
] key to return to radio operation.
Page 29