Scanning Operation - Standard Horizon HX210 Owner's Manual

Memory Scan (M-SCAN)

7.9.3 SCANNING OPERATION

7.9.3.1 Memory Scanning (M-SCAN)
1. Set the scan type to "M-SCAN" in the SETUP menu (refer to "7.9.2 SE-
LECTING SCAN TYPE").
2. Press the [SQL] switch, then press the [▲]/[▼] key until background
noise disappears.
3. Press one of the soft keys.
4. Press the [◄]/[►] key repeatedly, until the [SCAN] soft key is displayed
at the bottom of the LCD.
5. Press the [SCAN] soft key. "MEM SCAN"
appears on the display. Scanning will pro-
ceed from the lowest to the highest pro-
grammed channel number and preset chan-
nel (described in the next section) and will
stop on a channel when a transmission is
received.
The channel number will blink during reception.
6. To stop scanning, press the [16/S] or [CLR/
7.9.3.2 Priority Scanning (P-SCAN)
1. Set the scan type to "P-SCAN" in the SETUP menu (refer to "7.9.2 SE-
LECTING SCAN TYPE").
2. Press the [SQL] switch, then press the [▲]/[▼] key until background
noise disappears.
3. Press one of the soft keys.
4. Press the [◄]/[►] key repeatedly, until the [SCAN] soft key is displayed
at the bottom of the LCD.
5. Press the [SCAN] soft key. "PRI SCAN" appears on the display. Scan-
ning will proceed between the memorized channels and preset channel
and the priority channel.
The priority channel will be scanned after each programmed channel.
6. To stop scanning, press the [16/S] or [CLR/
HX210
Preset
Channel 0
Preset
Channel 5
Preset
Channel 4
Priority Channel
Scan Memory
Channel
Preset
Channel 3
Scan Memory
Channel
Priority Scan (P-SCAN)
] key.
] key.
Scan Memory
Channel
Preset
Channel 1
Preset
Channel 2
Scan Memory
Channel
Page 23