Camera Commands; Xcommand Camera Positionreset; Xcommand Camera Positionset; Xcommand Camera Preset Activate - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

Camera commands

xCommand Camera PositionReset

Reset the camera position to default position.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera PositionReset [Axis: Axis] CameraId:
where
Axis: All/Focus/PanTilt/Zoom
Select which motor to reset. If not specified all are reset.
CameraId: Integer (1..1)
The ID of the camera preset you want to reset.
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration
CameraId
xCommand xCommand

xCommand Camera PositionSet

Set the camera position.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera PositionSet CameraId:
Tilt] [Zoom: Zoom]
where
CameraId: Integer (1..1)
The ID of the camera preset you want to reset.
Focus: Integer (0..65535)
Focus the camera near or far.
Pan: Integer (-10000..10000)
Move the camera to the left or right.
Tilt: Integer (-2500..2500)
Move the camera up or down.
Zoom: Integer (0..8500)
Zoom in or out.

xCommand Camera Preset Activate

Activate one of the stored camera presets.
Note that the xCommand Camera Preset commands applies to an individual camera. This is
in contrast to the xCommand Preset commands where a single preset covers ALL connected
cameras plus the Video Input switcher settings.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera Preset Activate PresetId:
where
PresetId: Integer (1..35)
The ID of the camera preset you want to activate.
106
API Reference Guide
xStatus Appendices
CameraId [Focus: Focus] [Pan: Pan] [Tilt:
PresetId
Copyright © 2016 Cisco Systems, Inc. All rights reserved.