Cisco TelePresence SX10 Reference Manual page 130

Cisco TelePresence SX10

Introduction
UserManagement commands
xCommand UserManagement RemoteSupportUser Create
Create a remote support user passphrase that Technical Assistance Center (TAC) can use to
access the system for troubleshooting.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser Create [ExpiryDays: ExpiryDays]
where
ExpiryDays: Integer (1..31)
Define the duration for the passphrase validity. Default is 7 days.
xCommand UserManagement RemoteSupportUser Delete
Delete the remote support user created with the command xCommand UserManagement
RemoteSupportUser Create.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser Delete
xCommand UserManagement RemoteSupportUser DisablePermanently
Disable the creation of new remote support users. To enable the remote support user again you
must factory reset your system.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser DisablePermanently Confirm:
where
Confirm: Yes
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration xCommand xCommand
xCommand UserManagement RemoteSupportUser GetState
Retrieves the state of the generated remote support user, if one exists.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser GetState
xCommand UserManagement User Passphrase Change
Change the passphrase for the user you logged in as. If you are logged in as the administrator,
this will change the administrator passphrase.
Requires user role: ADMIN, USER
USAGE:
xCommand UserManagement User Passphrase Change NewPassphrase: "NewPassphrase"
OldPassphrase: "OldPassphrase"
where
NewPassphrase: String (0, 255)
OldPassphrase: String (0, 255)
Confirm
130
API Reference Guide
xStatus Appendices
Copyright © 2016 Cisco Systems, Inc. All rights reserved.