Usermanagement Configuration; Xconfiguration Usermanagement Ldap Mode; Xconfiguration Usermanagement Ldap Server Address; Xconfiguration Usermanagement Ldap Server Port - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

UserManagement configuration

xConfiguration UserManagement LDAP Mode

The video system supports the use of an LDAP (Lightweight Directory Access Protocol)
server as a central place to store and validate user names and passwords. Use this setting
to configure whether or not to use LDAP authentication. Our implementation is tested for the
Microsoft Active Directory (AD) service.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration UserManagement LDAP Mode:
where
Mode
: Off/On
Off: LDAP authentication is not allowed.
On: Use LDAP authentication.

xConfiguration UserManagement LDAP Server Address

Set the IP address or hostname of the LDAP server.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration UserManagement LDAP Server Address: "Address"
where
Address
: String (0, 255)
A valid IPv4 address, IPv6 address or hostname.
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration xConfiguration
Mode
xCommand

xConfiguration UserManagement LDAP Server Port

Set the port to connect to the LDAP server on. If set to 0, use the default for the selected
protocol (see the UserManagement LDAP Encryption setting).
Requires user role: ADMIN
Default value: 0
USAGE:
xConfiguration UserManagement LDAP Server Port:
where
Port
: Integer (0..65535)
The LDAP server port number.

xConfiguration UserManagement LDAP Encryption

Define how to secure the communication between the video system and the LDAP server. You
can override the port number by using the UserManagement LDAP Server Port setting.
Requires user role: ADMIN
Default value: LDAPS
USAGE:
xConfiguration UserManagement LDAP Encryption:
where
Encryption
: LDAPS/None/STARTTLS
LDAPS: Connect to the LDAP server on port 636 over TLS (Transport Layer Security).
None: Connect to LDAP server on port 389 with no encryption.
STARTTLS: Connect to LDAP server on port 389, then send STARTTLS to enable TLS
encryption.
86
API Reference Guide
xStatus Appendices
Port
Encryption
Copyright © 2016 Cisco Systems, Inc. All rights reserved.