Audio Configuration; Xconfiguration Audio Defaultvolume; Xconfiguration Audio Soundsandalerts Ringtone; Xconfiguration Audio Soundsandalerts Ringvolume - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

Audio configuration

xConfiguration Audio DefaultVolume

Define the default volume for the speakers. The volume is set to this value when you switch on
or restart the video system. Use the Touch controller or remote control to change the volume
while the video system is running. You may also use API commands (xCommand Audio Volume)
to change the volume while the video system is running, and to reset to default value.
Requires user role: ADMIN, USER
Default value: 50
USAGE:
xConfiguration Audio DefaultVolume:
where
DefaultVolume
: Integer (0..100)
Select a value between 1 and 100. This corresponds to the dB range from -34.5 dB to
15 dB, in steps of 0.5 dB). If set to 0 the audio is switched off.

xConfiguration Audio SoundsAndAlerts RingTone

Define which ringtone to use for incoming calls.
Requires user role: ADMIN, USER
Default value: Sunrise
USAGE:
xConfiguration Audio SoundsAndAlerts RingTone:
where
RingTone
: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/
Calculation/Mellow/Ringer
Select a ringtone from the list.
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration xConfiguration
DefaultVolume
RingTone
xCommand

xConfiguration Audio SoundsAndAlerts RingVolume

Define the ring volume for incoming calls.
Requires user role: ADMIN, USER
Default value: 50
USAGE:
xConfiguration Audio SoundsAndAlerts RingVolume:
where
RingVolume
: Integer (0..100)
The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.

xConfiguration Audio Input Microphone [2] EchoControl Mode

The echo canceller continuously adjusts itself to the audio characteristics of the room, and
compensates for any changes it detects in the audio environment. If the changes in the audio
conditions are significant, the echo canceller may take a second or two to re-adjust.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Audio Input Microphone
where
n
: Unique ID that identifies the microphone input. Range: 2..2
Mode
: Off/On
Off: Turn off the echo control. Recommended if external echo cancellation or playback
equipment is used.
On: Turn on the echo control. Recommended, in general, to prevent the far end from
hearing their own audio. Once selected, echo cancellation is active at all times.
48
API Reference Guide
xStatus Appendices
RingVolume
n EchoControl Mode: Mode
Copyright © 2016 Cisco Systems, Inc. All rights reserved.