Xconfiguration Network [1] Ipv4 Address; Xconfiguration Network [1] Ipv4 Gateway; Xconfiguration Network [1] Ipv4 Subnetmask; Xconfiguration Network [1] Ipv6 Assignment - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

xConfiguration Network [1] IPv4 Address

Define the static IPv4 network address for the system. Applicable only when Network IPv4
Assignment is set to Static.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration Network n IPv4 Address: "Address"
where
n
: Index that identifies the network. Range: 1..1
Address
: String (0, 64)
A valid IPv4 address.

xConfiguration Network [1] IPv4 Gateway

Define the IPv4 network gateway address. Applicable only when the Network IPv4 Assignment
is set to Static.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration Network n IPv4 Gateway: "Gateway"
where
n
: Index that identifies the network. Range: 1..1
Gateway
: String (0, 64)
A valid IPv4 address.
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration xConfiguration xCommand

xConfiguration Network [1] IPv4 SubnetMask

Define the IPv4 network subnet mask. Applicable only when the Network IPv4 Assignment is
set to Static.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration Network n IPv4 SubnetMask: "SubnetMask"
where
n
: Index that identifies the network. Range: 1..1
SubnetMask
: String (0, 64)
A valid IPv4 address.

xConfiguration Network [1] IPv6 Assignment

Define how the system will obtain its IPv6 address and the default gateway address. This
setting only applies to systems on IPv6 networks.
Requires user role: ADMIN
Default value: Autoconf
USAGE:
xConfiguration Network n IPv6 Assignment:
where
n
: Index that identifies the network. Range: 1..1
Assignment
: Static/DHCPv6/Autoconf
Static: The codec and gateway IP addresses must be configured manually using the
Network IPv6 Address and Network IPv6 Gateway settings. The options, for example
NTP and DNS server addresses, must either be set manually or obtained from a
DHCPv6 server. The Network IPv6 DHCPOptions setting determines which method to
use.
DHCPv6: All IPv6 addresses, including options, will be obtained from a DHCPv6 server.
See RFC 3315 for a detailed description. The Network IPv6 DHCPOptions setting will
be ignored.
Autoconf: Enable IPv6 stateless autoconfiguration of the IPv6 network interface. See
RFC 4862 for a detailed description. The options, for example NTP and DNS server
addresses, must either be set manually or obtained from a DHCPv6 server. The
Network IPv6 DHCPOptions setting determines which method to use.
62
API Reference Guide
xStatus Appendices
Assignment
Copyright © 2016 Cisco Systems, Inc. All rights reserved.