Table of Contents
Advertisement
I Customer display
There are two customer display options available for the UP-X300.
The pole type customer display or an integrated type rear display can be installed.
A scrolling message (programmed text for terminal) can be displayed on the customer display. The scrolling
message is displayed from the right to left on the display.
I Screen save mode
The screen save function starts when the POS terminal is left idle for an extended period of time. You can
program the time for which your POS terminal should keep the normal status before it goes into the screen
saver mode. If the time has not been preset, the screen saver will be started after 100 minutes.
To exit the screen saver mode, touch anywhere on the touch panel (a secret code may be required at this
time).
I Backlight brightness control
It is possible to adjust the backlight brightness of the screen, touch the [Back Light] key. The following
window will be displayed. Move the slider to adjust the brightness and touch the [OK] button.
To switch the backlight off in the screen saver mode, touch to mark the "Auto Off" check box.
13
Advertisement
Table of Contents
