2 Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
For details about loading a document, see "Making Copies From the ADF" on page 235 or "Making Copies From
the Document Glass" on page 233.
3 Ensure that Scan to is highlighted, and then press the
You can also scan documents by the following steps.
Press the
(Scan) button.
a
Ensure that Scan to USB Memory is highlighted, and then press the
b
4 Press the
button to select the folder to store the scanned file in, and then press the
If you do not specify the folder, skip this step.
5 Configure the scan settings as necessary.
Settings such as file format and color mode are available. To configure these settings, press the
Preferences is highlighted, and then press the
Defaults" on page 168.
6 Ensure that Start Scan is highlighted, and then press the
Using the ID Scan
1 Perform steps 1 to 5 in "Basic Scanning Procedures" on page 268.
Be sure to place the ID card on the document glass.
2 Press the
until Start ID Scan is highlighted, and then press the
After the front side of the ID card is scanned, the display prompts you to turn it over.
To scan the rear side of the ID card, turn it over, press the
a
the
(Set) button.
To finish scanning without scanning the rear side of the ID card, press the
b
and then press the
(Set) button.
(Set) button.
(Set) button.
(Set) button. For details about setting items, see "Scan
(Start) button.
(Set) button.
until Continue is highlighted, and then press
until Save Now is highlighted,
(Set) button.
button until
269
Scanning