Verifying The Ip Settings; The Operator Panel; The System Settings Report; The Ping Command - Dell C1765NFW User Manual

Verifying the IP Settings

You can confirm the settings by using the operator panel, printing the printer settings report, or using the ping
command.
NOTE:
A password is required to enter
password you specified, and press the

The Operator Panel

1 Press the (Menu) button.
2 Press the button until System appears, and then press the
3 Press the button until Admin Menu appears, and then press the
4 Press the button until Network appears, and then press the
5 Press the
button until TCP/IP appears, and then press the
6 Press the button until IPv4 appears, and then press the
Check the IP address displayed on the operator panel.

The System Settings Report

1 Print the system settings report.
For details about how to print a system settings report, see "Printing a Report/List Using the Operator Panel" on
page 175.
2 Verify the correct IP address, subnet mask, and gateway address are listed in the system settings report under Wired
Network or Wireless Network.
If the IP address shows 0.0.0.0 (the factory default), an IP address has not been assigned. To assign one for your
printer, see "Assigning an IP Address" on page 53.

The Ping Command

Ping the printer and verify that it responds. For example, at a command prompt on a network computer, type ping
followed by the new IP address (for example, 192.168.0.11):
ping 192.168.0.11
If the printer is active on the network, you will receive a reply.
when
Admin Menu Panel Lock Set
(Set) button.
is set to
Enable
(set) button.
(set) button.
(set) button.
(set) button.
(set) button.
Setting the IP Address
. In this case, enter the
55