Sensor (Adf 1St Scan) Late Jam Service Check - Dell 5535dn Service Manual

Step
6 Check the sensor (ADF sheet through) for proper
connection.
Is the above component properly connected?
7 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
8 Perform a print test using the ADF.
Does the problem remain?

Sensor (ADF 1st scan) late jam service check

Use this procedure for the following jams:
• 290.02
Step
1 Check the original document condition.
Is the original document free of paper clips and staples as
well as damage such as creases, tears, holes or excessive
wear?
2 Check the ADF rolls for wear.
Is the ADF feed/pick roll assembly or the ADF separation roll
guide assembly free of excess wear?
3 Check the media path for contaminates.
Is the media path free of excess media dust and foreign
objects such as paper clips and staples?
2-114
Service Manual
Check
Check
Yes
Replace the Replace the
sensor (ADF connection.
sheet through).
Go to "Sensor
(ADF sheet
through)
removal" on
page 4-82.
Replace the ADF Problem solved.
controller card
assembly.
Go to "ADF
controller card
removal" on
page 4-67.
Go to step 11.
Contact next Problem solved.
highest level of
tech support.
Yes
Go to step 2. Remove damaged
original document
and replace with a
new undamaged
original document.
Perform a ADF
test. If the
problem remains,
go to step 2.
Go to step 3. Clean or replace
the ADF feed/pick
roll assembly or
the ADF
separation roll
assembly.
Go to "ADF feed /
pick roll
assembly
removal" on
page 4-61 or
"ADF separator
torque limiter
assembly
removal" on
page 4-63.
Go to step 4. Remove all
contaminates
from the media
path.
No
No