System Settings - Dell C1765NFW User Manual

Protocol Monitor
Purpose:
To set whether to print a protocol monitor report, which helps you identify the cause of a communication problem.
Values:
Print Always Prints a protocol monitor report after every fax transmission.
Print On Error Prints a protocol monitor report only when an error occurs.
Print Disable* Does not print a protocol monitor report after a fax transmission.
Country
Purpose:
To select the country where the printer is used.

System Settings

Use the System Settings menu to configure a variety of printer features.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
Power Saving Timer
Purpose:
To specify the time for transition to power saver mode.
Values:
Sleep 5min*
Available Range:
5–30min
Deep Sleep 6min*
Available Range:
1–6min
Enter 5 in Sleep to put the printer in the power saver timer mode five minutes after it finishes a job. This uses less
energy, but requires more warm-up time for the printer. Enter 5 if your printer shares an electrical circuit with room
lighting and you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer ready to operate
with minimum warm-up time. Select a value between 5 and 30 minutes for the power saver timer mode if you want
a balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the power saver timer mode when it receives data from
the computer. You can also return the printer to the standby mode by pressing any button on the operator panel.
188
Understanding the Printer Menus
Specifies the time taken by the printer before it enters Sleep mode after it finishes a
job.
Specifies the time taken by the printer before it enters Deep Sleep mode after it goes
into Sleep mode.