Fax Settings - Dell C1765NFW User Manual

Fax Settings

Purpose:
To configure the basic fax settings.
Values:
Receive Mode Telephone
Fax
Telephone/Fax
Ans Machine/Fax
DRPD
Auto Rec Fax Available Range:
0–255 seconds
Auto Rec Fax/Tel Available Range:
0–255 seconds
Auto Rec Ans/Fax Available Range:
0–255 seconds
Line Monitor Off
Low
Medium
High
Ring Tone Volume Off
Low
Medium
High
Line Type PSTN
PBX
Tone/Pulse Tone
Pulse (10PPS)
Pulse (20PPS)
Resend Delay Available Range:
3–255 seconds
Redial Attempts Available Range:
0–9
Automatic fax reception is turned off. You can receive a fax by picking up the
handset of the external telephone, and then pressing the remote receive code.
Automatically receives faxes.
When the printer receives an incoming fax, the external telephone rings for the
time specified in Auto Rec Fax/Tel, and then the printer automatically receives a
fax. If an incoming call is not a fax, the printer beeps from the internal speaker
indicating that the call is a telephone call.
The printer can share a telephone line with an answering machine. In this mode,
the printer will monitor the fax signal and pick up the line if there are fax tones. If
the phone communication is using serial transmission in your country (such as
Germany, Sweden, Denmark, Austria, Belgium, Italy, France and Switzerland), this
mode is not supported.
Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctive
ring service must be installed on your telephone line by the telephone company.
After the telephone company has provided a separate number for faxing with a
distinctive ring pattern, configure the fax setup to monitor for that specific ring
pattern.
Sets the interval at which the printer goes into the fax receive mode after receiving
an incoming call.
Sets the interval at which the printer goes into the fax receive mode after the
external telephone receives an incoming call.
Sets the interval at which the printer goes into the fax receive mode after the
external answering machine receives an incoming call.
Turns off the volume of the line monitor.
Specifies the volume of the line monitor, which audibly monitors a transmission
through the internal speaker until a connection is made.
Turns off the volume of the ring tone.
Specifies the volume of the ring tone, which indicates that an incoming call is a
telephone call through the internal speaker when Receive Mode is set to
Telephone/Fax.
Sets the line type to PSTN.
Sets the line type to PBX.
Sets the dialing type to Tone.
Sets the dialing type to Pulse (10 pulse per second).
*1
Sets the dialing type to Pulse (20 pulse per second).
Specifies the interval between transmission attempts.
Specifies the number of redial attempts to make when the destination fax number
is busy. If you enter 0, the printer will not redial.
Understanding the Tool Box Menus
159