Deploying The Wndap350 Wireless Access Point - NETGEAR WNDAP350 Reference Manual

Configuring Wireless Access

To configure your wireless settings for 11b/bg/ng and 11a/na:
1. From the main menu under Configuration, select Wireless. The Wireless Settings
screen displays, as shown in
2. Enter the wireless settings for your area. See the online help or
page 25.
3. Click Apply to save your settings.
Figure 9. Basic Wireless Settings for 802.11b/bg/ng
When you have completed the setup steps, you can deploy the WNDAP350 in your network.
If needed, you can now reconfigure the computer you used in step 1 (from the Static IP) back
to its original TCP/IP settings.

Deploying the WNDAP350 Wireless Access Point


To deploy the WNDAP350 wireless access point:
1. Disconnect the WNDAP350 and position it where it will be deployed. The best location
is elevated, such as wall mounted or on the top of a cubicle, at the center of your
wireless coverage area, and within line of sight of all the mobile devices.
2. Lift the antenna on either side so that they are vertical.
Note: Refer to the antenna positioning and wireless mode configuration
information in
3. Connect an Ethernet cable from your WNDAP350 wireless access point to a LAN port on
your router, switch, or hub.
ProSAFE Dual Band Wireless N Access Point WNDAP350
Figure 9, Basic Wireless Settings for
Chapter 4, Advanced
Basic Installation and Configuration
Configuration.
22
802.11b/bg/ng.
Wireless Settings on