NETGEAR WNDAP350 Reference Manual page 40


To configure a Security Profile:
1. From your Web browser, log in to the WNDAP350 using the default LAN address of
http://192.168.1.1, user name admin and password password, or use the LAN address
and password that you set up.
2. Under the Configuration tab, select
Security Profile Settings for 802.11b/bg/ng or 802.11a/na. The screen for the Profile Settings
you selected displays as shown in
3. Select the check box of the profile you want to modify and click Edit. The Security Profile
Configuration screen for the selected profile displays (see
Figure 18. Edit a security profile
4. Give your profile a meaningful name so that you can remember it later.
5. The Wireless Network Name (SSID) is set by default to identify it as NETGEAR_11g.
6. Enable or disable the Broadcast Wireless Network Name (SSID). It is enabled by default. (If
it is broadcast, it can be easily detected by other clients.)
7. From the Network Authentication pull-down menu, select the Network Authentication Type
you want to use for this profile:
• To configure WEP encryption for Open Systems or Shared Key, see
on page 41.
• To configure WPA with RADIUS, see
• To configure WPA2 with RADIUS, see
• To configure WPA and WPA2 with RADIUS, see
RADIUS on page 44.
• To configure WPA-PSK, see
• To configure WPA2-PSK, see
• To configure WPA-PSK and WPA2-PSK, see
on page 46.
ProSAFE Dual Band Wireless N Access Point WNDAP350
Security
Figure 17, Security profile settings
Configuring WPA-PSK
Configuring WPA2-PSK
Basic Installation and Configuration
from the main menu, and then select either
Figure 18, Edit a security
Configuring WPA with RADIUS
Configuring WPA2 with RADIUS
Configuring WPA and WPA2 with
on page 45.
on page 46.
Configuring WPA-PSK and WPA2-PSK
40
above.
profile).
Configuring WEP
on page 42.
on page 43.