Restricting Wireless Access By Mac Address - NETGEAR WNDAP350 Reference Manual

Consult the product documentation for your wireless adapter; WPA client software for
instructions on configuring WPA settings and WPA2 client software for instructions on
configuring WPA2 settings.
Figure 25. Configure WPA-PSK and WPA2-PSK

To configure WPA-PSK and WPA2-PSK:
1. From the Network Authentication drop-down menu, select WPA-PSK & WPA2-PSK.
By default, Data Encryption will be set to TKIP+AES.
2. Enter the WPA Passphrase (Network Key).
3. Wireless Client Security Separation is disabled by default. If enabled, associated wireless
clients will not be able to communicate with each other. (This feature is intended for hotspots
and other public access situations.
4. Click Apply to save your settings.

Restricting Wireless Access by MAC Address

The optional Access Control window lets you block the network access privilege of any
specified stations through the WNDAP350 wireless access point. When you enable access
control, the access point only accepts connections from clients on the selected access
control list. This provides an additional layer of security.
Note: If configuring the WNDAP350 from a wireless computer whose MAC
address is not in the access control list, if you select Turn Access Control
On, you will lose your wireless connection when you click Apply. You
must then access the wireless access point from a wired computer or
from a wireless computer that is on the access control list to make any
further changes.
ProSAFE Dual Band Wireless N Access Point WNDAP350
Basic Installation and Configuration
47