Configuring A Wndap350 As A Point-To-Point Bridge - NETGEAR WNDAP350 Reference Manual

Figure 50. Bridging - Edit WDS Security Profile

Configuring a WNDAP350 as a Point-to-Point Bridge

Figure 51, Wireless point-to-point bridge setup
LAN
Segment 1
Figure 51. Wireless point-to-point bridge setup

To configure a point-to-point bridge
1. Under the Configuration tab, select Wireless Bridge. Then, select Bridging. The
Bridging screen displays (see
2. Configure the WNDAP350 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode.
3. Configure the WNDAP350 (AP2) on LAN Segment 2 in Point-to-Point Bridge mode.
AP1 must have AP2's MAC address in its Remote MAC Address field and AP2 must have
AP1's MAC address in its Remote MAC Address field.
ProSAFE Dual Band Wireless N Access Point WNDAP350
AP1
E T H E R N E T
5 - 1 2 V D C
AP in R E S E T
Point-to-Point
Bridge Mode
Router
Figure 49, Enable Wireless Point-to-Point
Advanced Configuration
shows a point-to-point bridge configuration.
AP in
Point-to-Point
Bridge Mode
Hub or Switch
76
AP2
E T H E R N E T
5 - 1 2 V D C
R E S E T
LAN
Segment 2
Bridge).