How Do I Use The Reset Button To Restore The Factory Default Settings - NETGEAR WNDAP350 Reference Manual

• If the WNDAP350 is configured correctly, check your Internet connection (DSL/Cable
modem etc.) to make sure that it is working correctly.
• Try again.
How do I use the Reset button to restore the factory
default settings?
The Reset button (see
• Reboot. When pressed and released quickly, the WNDAP350 will reboot (restart).
• Reset to Factory Defaults. This button can also be used to clear all data and restore all
settings to the factory default values.

To clear all data and restore the factory default values:
1. Power off the WNDAP350 and power it back on.
2. Use something with a small point, such as a pen, to press the Reset button in and hold it in
for at least 5 seconds.
3. Release the Reset button.
The factory default configuration has now been restored, and the WNDAP350 is ready for
use.
ProSAFE Dual Band Wireless N Access Point WNDAP350
Rear Panel on page 13) has two functions:
Troubleshooting and Debugging
82