Remote Console; Using The Secure Telnet Interface - NETGEAR WNDAP350 Reference Manual

Remote Console

The Remote Console configuration features are located under the Maintenance tab,
Remote Management, and then under Remote Console. Enter the following information in
the Remote Console screen, as shown in
• Secure Shell (SSH). If set to Enable, the Wireless Access Point will only allow remote
access via Secure Shell and Secure Telnet. The default is Enable.
• Telnet. If set to Enable, the Wireless Access Point will only allow remote access via
Telnet. The default is Disable.
Figure 28. Configure Remote Console

Using the Secure Telnet Interface

The WNDAP350 includes a secure Telnet command line interface (CLI). You can access the
CLI from a secure Telnet client over the Ethernet port or over the serial console port.
Note: You must use a secure Telnet client such as Absolute Telnet. Also,
when you configure the client, use the SSH1, 3DES option. If you use
the Telnet client to connect over the Ethernet port, use the IP address
of the WNDAP350 as the host name.

To use the CLI from a Console Port:
1. Using the null-modem cable, connect a VT100/ANSI terminal or a workstation to the port
labeled Console.
If you attached a PC, Apple Macintosh, or UNIX workstation, start a secure
terminal-emulation program.
ProSAFE Dual Band Wireless N Access Point WNDAP350
Figure 28, Configure Remote
Management
51
Console: