Configuring Advanced Qos Settings - NETGEAR WNDAP350 Reference Manual

• DTIM Interval. The Delivery Traffic Indication Message. Specifies the data beacon
rate between 1 and 255. The default is 3.
• Client Isolation. This option, when enabled, blocks communication between wireless
clients that are associated to different VAPs. The default is Disable.
• Max Wireless Clients. The number of wireless clients that can associate with the AP
at one time. The default is 63.
5. Click Apply to enable the Wireless Settings.

Configuring Advanced QoS Settings

Wireless Multimedia Extension (WME) or Wi-Fi Multimedia (WMM) is a subset of the 802.11e
standard. WME allows wireless traffic to have a range of priorities, depending on the type of
data. Time-dependent information, such as video or audio, has a higher priority than normal
traffic. For WME to function correctly, Wireless clients must also support WME.
Figure 48, Advanced QoS settings
networks, the default QoS queue parameter settings work well.Quality of Service provides
you with the ability to specify parameters on multiple queues for increased throughput and
better performance of differentiated wireless traffic, like Voice-over-IP (VoIP), other types of
audio, video, and streaming media, as well as traditional IP data.

To configure advanced QoS settings:
1. On the Configuration tab select Wireless, select Advanced, and then select QoS
Settings. The QoS Settings screen displays:
Figure 48. Advanced QoS settings
2. Specify the QoS options on the WNDAP350 are as follows:
• AP EDCA Parameters. Specify the AP EDCA (Enhanced Distributed Channel
Access) parameters for different types of data transmitted from the WNDAP350
wireless access point to the wireless client.
ProSAFE Dual Band Wireless N Access Point WNDAP350
shows the Quality of Service (QoS) screen. For most
Advanced Configuration
73