Configuring 802.11A/Na Wireless Settings - NETGEAR WNDAP350 Reference Manual

• Guard Interval. From the pull-down menu, select the desired guard interval. The
guard interval protects from interference from other transmissions. The default is
Auto.
• Output Power. From the pull-down menu, select the transmit power of the access
point. The options are Full, Half, Quarter, Eighth, and Minimum. Decrease the
transmit power if two or more APs are close together and use the same channel
frequency. The default is Full. (The transmit power may vary depending on the local
regulatory regulations.
3. Click Apply to save your 802.11b/bg/ng wireless settings.

Configuring 802.11a/na Wireless Settings


To configure the 802.11a/na wireless settings of your wireless access point:
1. From the main menu under Configuration, select Wireless, and then select the
802.11a/na tab. The Wireless Settings screen for your 11a/na access point displays as
shown in Figure 13, Basic Wireless Settings - 802.11a/na
Figure 13. Basic Wireless Settings - 802.11a/na
2. Configure the Wireless LAN settings based on the following field descriptions:
• Wireless Mode. Select the desired wireless operating mode. Only 802.11a/na
wireless modes can be selected from this menu. The default is 11na. The options are:
- 11a. All 802.11a wireless stations can be used.
- 11na. All 11a and 11na wireless stations can be used. This is the default.
Note: If you select one of these options and if other settings on this screen
are disabled, then you must select the Turn Radio On radio button to
enable available options on this screen.
ProSAFE Dual Band Wireless N Access Point WNDAP350
Basic Installation and Configuration
below.
28