Wireless Access Point (Ap) - NETGEAR R7000 User Manual

Click Add.
5.
The screen changes back to the list screen.
Add each computer or device you want to allow to connect wirelessly.
6.
Select the Turn Access Control On check box.
7.
Click Apply.
8.

To edit a wireless device or delete it from the access list:
Select Advanced > Advanced Setup > Wireless Settings.
1.
The Advanced Wireless Settings screen displays.
In the table, select the radio button next to the wireless device that you want to edit or delete.
2.
Do one of the following:
3.
Click the Edit button.
•
The Edit Wireless Card screen displays.
a. Edit the address information.
b. Click the Accept button.
Click the Delete button.
•
The address is removed from the table.

Wireless Access Point (AP)

You can set up the router to run as an access point (AP) on the same local network as
another router.

To set up the router as an AP:
Use an Ethernet cable to connect the Internet port of this router to a LAN port in the
1.
other router.
Select Advanced > Advanced Setup > Wireless Settings.
2.
Select the Enable Access Point Mode check box.
3.
R7000 Smart WiFi Router
Advanced Settings
94
Cable this port to a LAN port
on the other router