NETGEAR WNDAP350 Reference Manual page 75

• Wireless Point-to-Multi-Point Bridge. Select this only if this WNDAP350 is the Master
for a group of bridge-mode wireless access points. Select the Enable Wireless Client
Association option to enable wireless clients to associate with this access point.
The other bridge-mode wireless access points must be set to point-to-point bridge mode,
using the MAC address of this WNDAP350. They then send all traffic to this Master,
rather than communicate directly with each other.
When you click the Edit button, you must enter the profile name and the MAC address
(physical address) of the other bridge mode wireless station in the fields provided. WEP,
WPA-PSK, or WPA2-PSK are supported. WPA2-PSK can (and should) be used to protect
this communication.
The screens used to configure these options are located by selecting Wireless Bridge under
the Configuration tab (see
Figure 49. Enable Wireless Point-to-Point Bridge

To configure bridge settings on the Bridging page:
1. Select the Enable Wireless Bridging option.
2. Select one of the bridge mode options, Wireless Point to Point Bridge, or Wireless Point
to Multi-Point Bridge.
3. Select Enable Wireless Client Association, if you wish.
4. Click Edit to edit the security profile of the wireless bridge settings, as shown in
Bridging - Edit WDS Security Profile
ProSAFE Dual Band Wireless N Access Point WNDAP350
Figure 49, Enable Wireless Point-to-Point Bridge
below.
Advanced Configuration
75
below).
Figure 50,