Flex Shadow Settings - Sony DVS-9000 User Manual

Flex Shadow Settings

This effect applies a shadow to the picture using only one channel.
For a sample illustration and other information, see "Digital Multi Effects
(DME)" in Chapter 1 (Volume 1).
Notes
• The Flex Shadow function is not supported on the MVE-8000A.
• "Mix Color" or "Ext Video"can only be applied to one of the background
(see page 123), flex shadow, trail (see page 104), and wind (see page 112)
effects.
If you select "Mix Color" or "Ext Video" in one of these settings, a selection
of "Mix Color" or "Ext Video" in any of the other effects is disabled, and
"Flat Color" is selected in its place.
• When executing combining four channels of DME images, "Mix Color" and
"Ext Video" in the flex shadow and background effects cannot be selected.
Applying a flex shadow
1
2
3
40
DME Special Effect Operations
In the DME menu, select VF1 'Edge' and HF5 'Flex Shadow.'
The Flex Shadow menu appears.
Press [Flex Shadow], turning it on.
This enables flex shadows, and you can now use the knobs to adjust the
parameters.
Note
The Flex shadow function cannot be enabled when the following functions
are enabled.
• Any nonlinear effect
• Brick
• Shadow
Adjust the following parameters.
The valid ranges of the parameter values depend on the aspect ratio (4:3/
16:9) selected in the system, as follows.
• 4:3 mode
Knob Parameter Adjustment
1 H Move shadow horizontally
2 V Move shadow vertically
Setting values
–8.00 to +8.00
–6.00 to +6.00