Setting The Signal Format (Format Menu) - Sony DVS-9000 User Manual

2
3
Setup in "Dual Simul" mode
When the system operation mode (see page 274) is set to "Dual Simul," the
following setting is required for setup of the two switchers and connected DME
units.
In the <Setup Target> group, set the [System 1] or [System 2] button to On,
then carry out the setup. You can also set both to On, and make the settings
simultaneously on the two systems.

Setting the Signal Format (Format Menu)

To set the format, that is, the frame frequency and number of scan lines handled
by each device, use the System >Format menu.
To display the Format menu
In the Engineering Setup menu, select VF1 'System' and HF3 'Format.'
Note
After changing any of the following settings, be sure to press [Execute] to save
the new values. If you want to cancel the settings and return to the original
state, press [Clear] without pressing [Execute].
276
Setup for the Whole System
Using either of the following methods, select the switcher to which the
settings apply.
• In the list appearing in the menu, press the desired device name.
• Press the arrow keys to scroll the reverse video cursor.
The selected switcher appears in reverse video.
If there is only one switcher on the network, carry out the SWR1 setting
(for the first switcher) only.
Make the DME settings as follows.
• When making DME settings for SWR1 (the first switcher), for the
first DME, select [DME1] in the <1st DME> group. For the second
DME, select [DME2] in the <2nd DME> group. When a second DME is
not connected, turn all buttons in the <2nd DME> group off.
• When making DME settings for SWR2 (the second switcher), for the
first DME, select [DME3] in the <1st DME> group. For the second
DME, select [DME4] in the <2nd DME> group. When a second DME is
not connected, turn all buttons in the <2nd DME> group off.