Resetting The Rtd - Mitsubishi Electric M32R Series User Manual

Mitsubishi 32-bit risc single-chip microcomputers

Table of Contents

14.3.8 Resetting the RTD

The RTD is reset by applying a system rest (i.e., by entering the RESET signal). The status of the

RTD related output pins after a system reset are shown below.

Table 14.3.2 RTD Pin State after System Reset

The first command transfer to the RTD after it was reset is initiated by transferring data to the

RTDRXD pin synchronously with falling edges of RTDCLK.

System reset

Note : (An) = Specified address

D (An) = Data at specified address (An)

Figure 14.3.13 Command Transfer to the RTD after System Reset

High-level output

REAL-TIME DEBUGGER (RTD)

14.3 Functional Description of the RTD