Samsung iDCS 500 Programming Manual page 391

iDCS 500
TECHNICAL MANUAL
MMC: 831
DESCRIPTION:
Provides a means to means to apply the Internet Protocol (IP) address to the ITM3
card. This MMC also assigns the number of channels that can be used for IP faxes.
The CLIP tables allow the calling station number to be received at the far end ITM3
location.
NOTE: This MMC cannot be accessed unless there is an ITM3 card installed in the
system.
NOTE: Programming MUST be exited before changes to the ITM3 take effect.
• IP ADDRESS: Specifies the IP address for the ITM3 card. When changing the
address three digits must be input for each field. Example (Default: 1.1.1.1).
NOTE: If the ITM3 IP address is changed the ITM3 card must be restarted.
NOTE: When default IP address is changed the Gateway IP address MUST
be changed also.
• SUBNET MASK: Specifies the IP subnet mask. When changing the address
three digits must be input for each field. (Default: 255.255.255.0)
• GATEWAY: Specifies the LAN gateway address when leaving the local network.
When changing the address three digits must be input for each field. (Default:
1.1.1.1)
• STS Period: Status Send Period designates the timed message cycle to check
the remote IP status (Range: 0~60 sec.) Default 00. Do not modify without
Samsung Telecommunications America's Technical Support Department.
• MAX FAC CH: Maximum facsimile channels. Specifies the maximum number of
ITM3 channels that will accept IP facsimiles (Default: 0)
• CLIP: Calling Line Identification Presentation. This provides the calling station
number when calling from one ITM3 location to another ITM3 location. Five
options are available: NONE, Table#. IDCS 500 M software supports 2 tables
and L software supports 4 tables.
PART 2 JANUARY 2003
VoIP PARAMETERS
HOME
PAGE
PROGRAMMING
Table of
Contents
HELP