Samsung iDCS 500 Programming Manual page 168

iDCS 500
TECHNICAL MANUAL
2 DLSEND
3 SWH
4 TIMER
OPTIONS FOR BRI PORTS PROGRAMMED AS STATIONS IN MMC 427
0 ANY CHANNEL
1 POWER FEED
2 SWH
3 TIMER
4 CLI TABLE
MMC: 425
OVERLAP Digits will be sent as they are dialed by the
user. This is the usual setting for the U.S.
operation.
ENBLOCK Digits will be collected and sent in a single
block similar to a Cell phone. This setting is
generally not used in the U.S.
The ISDN protocol you wish to run on this BRI
circuit (e.g., NI_2, 5ESS10, DMS100).
The ISDN T200 and T300 series timer values
(note: do not change these since defaults are
correct for U.S. operation).
When this option is set to YES, the system will
place calls on any free channel of that BRI if
the channel chosen by the user is busy (i.e.,
Preferred channel selection). If set to NO, the
user will receive a busy signal if they attempt to
access a busy channel even if the other
channel on that BRI is free (i.e., Exclusive
channel selection).
This is set to NO for all U.S. applications.
The ISDN protocol you wish to run (e.g., NI_2,
5ESS10, DMS100).
The ISDN T200 and T300 series timer values
(note:do not change these since defaults are
correct for U.S. operation).
This refers to the table in MMC 321 that will be
used for Calling party number (the CLI that is
sent).
PROGRAMMING
PART 2 JUNE 2002
Table of
Contents
HOME
PAGE
HELP