Samsung iDCS 500 Programming Manual page 215

iDCS 500
TECHNICAL MANUAL
is busy, calls will go to the third member etc. This type of group is useful for
placing the bulk of the incoming calls to a selected individual, with other
members only getting the calls when the first member is busy. The number
of members allowed for a sequential group is 48.
2. DISTRIBUTED: The first call will go to the first member, the second call will
go to the second member, the third call will go to the third member. This type
of group is useful for evenly distributing the call among all group members.
The number of members allowed for a distributed group is 48.
3. UNCONDITIONAL: Calls are placed to all group members simultaneously.
This reduces the number of members of the groups to 32. If a group member
is busy, they can receive off hook ring if defined in MMC 300.
This ring mode option is not available for AA UCD or VMAA groups.
C. OVERFLOW: This is the timer value that will cause unanswered calls to a group
to begin also ringing the NEXT PORT (see below) after this timer has elapsed. If
set to 000, no overflow will take place.
D. NEXT PORT: This is the station or group number that callers will also ring at if
the OVERFLOW feature has been programmed. The OVERFLOW DESTINATION
can be defined as:
1. COMMON BELL There are up to 6 relays available in the iDCS 500 system
that can be defined as Common bell in MMC 218. (2 on each PMISC card)
2. RING OVER PAGE DN # 362 and 363 (or 3062-3063 depending on SW5
setting on PMCP card) are the default numbers available on the PMCP
3. STATION OR STATION GROUP. Any station or station group can be
defined as the NEXT port.
E. GRP TRANSFER: This is a timer that will determine how long C.O. calls
transferred to the group will ring at the group before recalling. If set to 000, no
recall will take place.
F. MEMBER: List all members that are to be in the group. Up to 48 members are
allowed in each group, but stations can be assigned to multiple station groups.
G. NXT HUNT: The length of time a call will ring at a station before it hunts to the
next group member. (L version only)
H. GROUP BUSY: OFF
receive a busy signal when calling the group and all members of the group are
MMC: 601
When this option is set to ON an intercom caller will
PROGRAMMING
PART 2 JULY 2003
Table of
Contents
HOME
PAGE
HELP