Set Encryption - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > set encryption

set encryption

This command specifies whether encryption mode is enabled or disabled. When the encryption mode is
enabled, "Fujitsu" or "AES" should be specified as the kind of encryption. After switching the encryption mode
from enabled to disabled, the ETERNUS DX Disk storage system power must be turned off and back on again
to apply the setting. When switching the encryption mode from disabled to enabled, this operation is not
required.
Encryption-related functions may not be available for some user environments.
■ Syntax
set encryption -mode {fujitsu | aes | disable}
■ Parameter
-mode
■ Example(s)
The following example enables the Fujitsu encryption mode function:
CLI> set encryption -mode fujitsu
The following example disables the encryption mode functions,
and then reboots the ETERNUS DX Disk storage system to apply the setting:
CLI> set encryption -mode disable
CLI> shutdown -mode reboot
This parameter specifies encryption mode.
fujitsu Encryption mode is enabled. (Fujitsu)
aes Encryption mode is enabled. (AES)
disable Encryption mode is disabled.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
565
P2X0-1030-09ENZ0