Fujitsu ETERNUS DX80 S2 Cli User's Manual page 201

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show fc-parameters
■ Output
# Port
 Each host interface port number
# Port Mode
 It shows if either CA or RA mode is set. The RA mode is used for Remote Equivalent Copy.
# Connection
 Connection condition of each FC port (loop connection (FC-AL) or fabric connection)
# Loop ID Assign
 How to assign the loop ID (Loop ID is shown only when selecting manual.)
(Either ascending order or descending order is shown when selecting automatic.)
# Transfer Rate
 FC transfer rate (Auto Negotiation / 1Gbit/s / 2Gbit/s / 4Gbit/s / 8Gbit/s / 16Gbit/s)
# Frame Size
 FC frame size (512bytes/1024bytes/2048bytes)
# Host Affinity
 Host affinity mode of each host interface port
# Host Response No.
# Host Response Name
 Host response number (The hyphen is shown when the host affinity mode is enabled.)
# Reset Scope
 Range of reset action I_T_L (I: Initiator, T: Target, L: LUN) or T_L (T: Target, L: LUN)
# Reserve Cancel at Chip Reset
 It shows whether reservations are canceled or not when a host interface port is reset.
# REC Line No.
 REC line number (0 – 127)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Sync
 Synchronous mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Stack
 Asynchronous stack mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Consistency -
 Asynchronous consistency mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Through
 Asynchronous through mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
CM#0 CA#0 Port#0 CM#0 CA#0 Port#1
CA CA
FC-AL FC-AL
Manual(0x01) Auto(Ascending)
Auto Negotiation 4Gbit/s
2048bytes 512bytes
Disable Enable
5 -
HP05 -
I_T_L I_T_L
Disable Enable
- -
- -
- -
-
- -
201
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
CM#0 CA#0 Port#2 CM#0 CA#0 Port#3
RA Initiator
Fabric Fabric
Auto(Descending) Manual(0x01)
4Gbit/s 4Gbit/s
- -
- -
- -
-
- -
- -
127 -
Enable -
Disable -
Enable -
Disable -
P2X0-1030-09ENZ0