Set Role - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.1 User Management > set role

set role

This command changes the registered user-defined role information. Note that this command cannot change
the role name or the role types. This command can also change the role that is currently assigned to the user.
Any changes are enabled after the next login.
■ Syntax
set role -role-name
■ Parameter
-role-name This parameter specifies a role name. Two or more parameters cannot be specified at the same
-policy
■ Example(s)
The following example specifies "Resource Domain Management" policies for Role1.
CLI> set role -role-name Role1 -policy 10
role_name [-policy policy
time.
Optional. This parameter specifies policies to set for the role. Use the numbers that are listed
below to specify policies. Multiple policies can be specified at the same time. Enter a comma
(,) or a hyphen (-) between numbers to specify multiple policies. Note that spaces are not
permitted before or after commas (,).
If omitted, this parameter is not changed.
1 Status Display
2 RAID Group Management
3 Volume - Create/Modify
4 Volume - Delete/Format
5 Host Interface Management
6 Advanced Copy Management
7 Copy Session Management
8 Storage Migration Management
9 Resource Domain Management (not supported)
10 Storage Management
11 User Management
12 Authentication/Role
13 Security Setting
14 Audit Setting (not supported)
15 Maintenance Information
16 Maintenance Operation
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
]
359
P2X0-1030-09ENZ0