Mmc: 416 E&M/Did Ring - Samsung OfficeServ 7400 Technical Manual

OfficeServ 7400
TECHNICAL MANUAL
MMC: 416
DESCRIPTION:
This MMC defines which ring destination an E&M or DID trunk will follow for
incoming calls. There are three options for each trunk as defined below.
1. FOLLOW INCOM DGT
2. FOLLOW DID TRANS
3. FOLLOW TRK RING
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
ANS/RLS Used to select ALL
ACTION
1. Press TRANSFER 416
Display shows
When a trunk is set to this option calls will ring at the
destination that matches the digits received from the
CO. This is the same as the current UNUSE DID
TRANS option. It will operate like an E&M Tie Line.
When a trunk is set to this option calls will ring at the
destination defined in MMC 714 that matches the
digits received from the CO. This is the same as the
current USE DID TRANS option. This is used when
E&M Tie Line (both way DID Service) are used to
provide DID service.
If this option is selected, press the right soft key and
[No. REV DIGIT:00] will appear on the display. Here
is where the number of incoming digits from C.O.
must be entered (00 through 16). When a trunk is set
to this option calls will ring at the destination defined
in MMC 406 for that trunk. If the destination defined in
MMC 406 is a VMAA port or group then the system
will repeat the digits received from the CO to the
VMAA port when it answers.
DISPLAY
[ 701] EM/DD RING
FOLLOW DID TRANS
Home Page
PROGRAMMING
PART 2 JUNE 2006
E&M/DID RING
Table of Contents