Samsung OfficeServ 7400 Technical Manual page 280

OfficeServ 7400
TECHNICAL MANUAL
3. PRI = DID priority option. There are 9 priority levels: priority 1 is the highest and
priority 9 is the lowest.
When calls arrives into a station group and group members are all busy the call
is queued. The system will assign a priority to the DID number so that calls from
a high priority DID number will be placed at the front of the group queue.
4. 1: XXX, 2: XXX, 3: XXX, 4: XXX, 5: XXX, 6:XXX = ring plan and destination during
each ring plan. The destination can be a station, station group, trunk or trunk
group. If trunk or trunk group is selected the trunks must be programmed as
E&M trunks to allow the received digits to be re-sent on the facility(s). This is
referred to as DID Repeat digits over tie line.
NOTE: An entry of the character "B" means to repeat the received digits.
5. CW: Call waiting Yes/No . Allow a second DID call to be received
6. MC: This is the maximum number of simultaneous calls to this DID the system
will allow. If more call attempts are made the system will return a busy signal to
the caller.
7. DC: The number of digits to delete. This is useful with Tandem switching, mixed
numbering plans and DID Repeat digits over tie line. Maximum number of digits
that can be deleted is 16.
8. NAME: Input up to 11 characters to identify call.
Names are written using the keypad. Each press of a key selects a character.
Pressing the dial pad key moves the cursor to the next position. For example, if
the directory name is "SAM SMITH," press "7" three times to get the letter "S."
Press "2" once to get "A." Continue selecting characters from the table below to
complete your message. Pressing the bottom left programmable key changes
the letter from upper case to lower case.
NOTE: When the character you want appears on the same dial pad key as the
previous character, press the UP key to move the cursor to the right.
9. TONE: Ring tone options for a specific DID number (No. 1~8).
10. CAD: Ring cadence options for a specific DID number at SLT's (No. 1~5).
MMC: 714
Table of Contents
Home Page
PROGRAMMING
PART 2 JUNE 2006