Samsung OfficeServ 7400 Technical Manual page 356

OfficeServ 7400
TECHNICAL MANUAL
ALM ALM
NO. CODE
01 MJA01
02 MJA02
03 MJA03
04 MJA04
05 MJA05
06 MJA06
MJA10
08 MJB01
09 MJB02
10 MJB03
11 MJB04
12 MJB05
13 MJB06
14 MJB07
15 MJC01
16 MJC02
17-23 NOT USED
24 MJC10
25 MJC11
26 MJC12
27 MJC13
28-29 NOT USED
30 MJC16
31 MJC17
32 MJD01
33 MJD02
MMC: 852
ALARM CODE DEFINITIONS
ALARM
POR Restart
Button Restart
Mem Reset
Watchdog Reset
LCP Reset
PCM Switching
S/W Exception Err
HDLC Com Error
Memory Alarm 1
Memory Alarm 2
Memory Alarm 3
Memory Alarm 4
IPC MSGQ Over
Task MSGQ Over
DTMF Fault
Tone Fault
AA-DTMF Fault
AA-DTMF Rec
E911 Restart
E911 Block
WLI Restart
WLI Block
Sync Failure
Sync Recovery
Home Page
PROGRAMMING
PART 2 JUNE 2006
DEFINITION
MCP restart process has been
executed via power on restart (POR).
MCP restart process has been
executed via button reset or MMC 811.
The system RAM has been cleared via
manual programming (OfficeServ™
WebMMC) resulting in a system reset.
The MCP has reset (Watchdog Reset)
An LCP has reset
A fault has occurred in the Switching
Control.
Other kinds of System Restarts
Communications to Expansion Control
Processor lost or faulty.
A RAM diagnostic check error has
occurred in the MCP.
The IPC message queue is over 80% full
The IPC message queue is now back
under 80% full
An abnormal interrupt has occurred
in the system DTMF resources.
An abnormal interrupt has occurred
in the system tone resources. IE
busy, ringback, error, no more calls
etc.
An abnormal fault reported in one of the
systems AA card DTMF resources.
An abnormal fault reported in one of the
systems AA card DTMF resources has
recovered.
An E911 card has rebooted
An E911 card could not be accessed
The WLI card has restarted
The WLI card could not be accessed
Clocking on T1/PRI cards has become
asynchronous.
Clocking on T1/PRI cards has become
synchronous.
Table of Contents