Samsung OfficeServ 7400 Technical Manual page 327

OfficeServ 7400
TECHNICAL MANUAL
4 CTI LINK OPTION
5 ITP DSP PARA
6 ITP TX GAIN/HSET
7 ITP RX GAIN/HSET
MMC: 841
1 ALIVE TIME: This is a EasySet link via LAN alive check
timer.
Sets CTI link via LAN option with the system.
0 SMDR REPORT: Sets YES or NO for SMDR data to CTI link via
LAN.
1 UCD REPORT: Sets YES or NO for UCD data to CTI link via
LAN.
2 ALIVE TIME: This is a CTI link via LAN alive check timer. If
this sets 0, the system will not check link alive.
Sets IP phone DSP parameters of system-wide.
0 M-FRAME: This value determines the transmission interval
time of VoIP packets generated by the IP phone. This data
is effective only when DOWN = SYS DATA in this MMC.
The range is 10~40 ms. Applies only to ITP to ITP calls
(when both ITPs are in same zone).
1 JITTER: Decides the minimum time to consider delay for
jitter adjustment. This data is effective only when DOWN =
SYS DATA in this MMC. The range is 10~90 ms. Applies
only to ITP to ITP calls (when both ITPs are in same zone).
2 TOS: An eight-bit binary value that will be utilized by
external routers, switches, etc(that optionally support TOS-
bit prioritization)-to identify the transport-priority value of
data packets generated by the IP phone. This value can
be left at default value(00000) if your network infrastructure
does not support this method of bandwidth management.
This data is effective only when DOWN = SYS DATA in this
MMC. Applies only to ITP to ITP calls (when both ITPs are
in same zone).
3 CONTROL: Determines data uses system-wide data or each
phone data for IP-based phone DSP control.
a) SYS BASE: System-wide data will be used.(MMC 841
data)
b) ITP BASE: Each phone data will be used.(MMC 840
data)
c) CODE C: Choose codec priority MGI or ITP .
Sets IP-based phone Handset TX gain value of each level.
Sets IP-based phone Handset RX gain value of each level.
Table of Contents
Home Page
PROGRAMMING
PART 2 JUNE 2006
0 SEC
-
NO
NO
300 SEC
-
10 ms
20 ms
all bits 0
SYS BASE
-
-