Security; Ip Filter Configuration - Huawei EchoLife HG8110 Service Manual

EchoLife HG8010/HG8110/HG8240/HG8245/HG8247/
HG8447 GPON Terminal
Service Manual
NOTE
l The security mode and encryption configured on a Wi-Fi terminal must be the same as those of an ONT. If
the TKIP&AES, or AES encryption mode is not configured on the Wi-Fi terminal, the Wi-Fi terminal may
have an old-version driver. If so, update the driver version.
l When two SSIDs are configured, if you modify the information of an SSID, the other SSID will re-choose
a channel, causing the service to be interrupted for a few minutes.

5.5 Security

This topic describes how to configure the IP address filter, MAC address filter, DoS, and ONT
access control through the Web page.

5.5.1 IP Filter Configuration

1.
Figure 5-17 IP Filter Configuration
2.
The IP address filter function is a security mechanism configured on the residential gateway. It
enables or disables all or partial ports in an Intranet IP address segment to communicate with
all or partial ports in an Extranet IP address segment. The IP address filter configuration is used
to limit communication between an Intranet device and an Extranet device.
Table 5-5
Issue 02 (2011-12-08)
In the navigation tree on the left, choose Security > IP Filter Configuration. In the pane
on the right, enable the IP address filter function. After selecting the filter mode, click
New. Then, in the dialog box that is displayed, configure the rule for filtering IP addresses
from the WAN interface to the LAN port, as shown in
Click Apply to apply the configuration.
describes the parameters related to the IP address filter.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Web Page Reference
Figure 5-17.
317