Huawei EchoLife HG8110 Service Manual page 253

EchoLife HG8010/HG8110/HG8240/HG8245/HG8247/
HG8447 GPON Terminal
Service Manual
l
Context
Every data change must be saved. You can click Save in a window to save data changes. If you
navigate to another node without saving data changes, a dialog box will be displayed prompting
you to save the data changes. In this case, click YES in the dialog box. New data will be
automatically applied to the ONTs after the data changes are saved.
When configuring services on the U2560, do not modify the WAN interface connecting the
U2560 and the ONT. Otherwise, the U2560 loses communication with the ONT.
Procedure
Step 1 Log in to the U2560 and choose Subnet View > TR069 Subnet from the navigation tree. In the
terminal list, right-click an ONT and choose Tools > Configure in Real Time from the shortcut
menu.
Step 2 In the Configure in Real Time dialog box, set Root Node to Internet gateway device.
Step 3 Configure the parameters of the voice WAN interface.
1.
2.
Issue 02 (2011-12-08)
Two telephone sets must be available and each must be connected to ports TEL1 and TEL2
respectively on the ONT.
CAUTION
Choose InternetGatewayDevice > WANDevice > 1 > WANConnectionDevice from the
navigation tree. Click Add in the lower left part to create an instance.
Choose 2 > WANIPConnection from the navigation tree. Click Add in the lower left part.
Choose 1 from the navigation tree. In the right pane, set the parameters as follows:
l Set Enable to 1, indicating that the WAN connection is enabled.
l Set Connection Type to IP_Routed, indicating that the connection type of the WAN
interface is in routing mode.
l Set Addressing Type to DHCP, indicating that the WAN interface obtains IP addresses
in DHCP mode.
l Set X_HW_SERVICELIST to VOIP, indicating that the WAN interface provides the
VoIP access service.
l Set X_HW_VLAN to 20, indicating the VLAN ID of the WAN interface is 20.
l Set X_HW_PRI to 6, indicating that the priority level of the WAN interface is 6.
NOTE
l If the WAN interface obtains IP addresses in static or DHCP mode, choose WANIPConnection to
set parameters of the voice WAN interface.
l If the WAN interface obtains IP addresses in PPPoE mode, choose WANPPPConnection to set
parameters of the voice WAN interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuration
245