Table of Contents
Advertisement
Initial System Turn Up
Provision L100 Tributary Blade and Ports
Note: If autoprovisioning is enabled, the logical port is automatically provisioned.
Command:
% set eqpt shelf 2 slot 0 subslot 0 port L1 pluggableInterfaceType Logical num-
lanes 128 admin-status up
Step 6
Provision the OSC port.
Note: If autoprovisioning is enabled, the OSC port is automatically provisioned.
Command:
% set eqpt shelf 2 slot 0 subslot 0 port OSC pluggableInterfaceType OSC admin-
status up
Step 7
Provision the E-SC-E1 port equipment.
Note: If autoprovisioning is enabled, the E-SC-E1 port is automatically provisioned.
Note: If a 100ME SFP is being used, specify 100ME for pluggableInterfaceType.
Command:
% set eqpt shelf 2 slot 0 subslot 0 port E-SC-E1 pluggableInterfaceType 1GEX admin-
status up
Important: Fujitsu does not recommend using third-party OSC SFP module because the performance
of third-party OSC module is not guaranteed.
Step 8
Provision the E-SC-E1 port interface.
Note: If autoprovisioning is enabled, the E-SC-E1 port interface is automatically provisioned.
Command:
% set interfaces interface eth-2/0/0/E-SC-E1 type ethernetCsmacd ethernet admin-
status up mtu 1800 speed 1000
Step 9
Provision the UTLP equipment.
Command:
% set eqpt shelf 2 slot 0 subslot 0 port UTLP pluggableInterfaceType Fixed
Note: If a user provisions any UTLP equipment in an earlier release, use the following commands.
Commands:
% delete eqpt shelf 2 slot 0 subslot 0 port UTLP
% set eqpt shelf 2 slot 0 subslot 0 port UTLP pluggableInterfaceType Fixed
·
Release 19.1.1
Issue 1.1, May 2021
193
Fujitsu and Fujitsu Customer Use Only
Advertisement
Table of Contents
