Configure Lcn1 With Dhcp - Fujitsu 1FINITY L100 User Manual

Initial System Turn Up
Configure IP Connection to DCN
5.6.2

Configure LCN1 with DHCP

Prerequisites:
■ If port LCN1 requires a pluggable SFP module, the SFP is installed and its autoprovisioning is complete.
■ A DHCP server is operating on the LAN.
Overview
At the site where the NE is installed, the LAN connects to a router and the DCN is reachable through the router. A
DHCP server is operating on the LAN. LCN1 is configured with DHCP enabled by factory default. With this
configuration, the DHCP server automatically assigns an IP address to LCN1 when it is connected to the LAN. To
establish IP communication beyond the LAN, the user must configure the next-hop IP address on the NE routing
instance.
This section describes the procedure to configure the default next-hop IP address, and install a LAN cable
connecting LCN1 to the LAN. The LAN cable can connect directly to a LAN switch port as shown in the following
figure.
Virtuora NC
Virtuora User
NETCONF/
Interface
YANG
WebGUI
DCN
CLI
Remote Users
Figure 89
LAN Switch Port Connection
The following figure shows how to save LAN switch ports by connecting the LAN cable to a daisy chain of LAN
cable connections between 1FINITY NEs.
·
Release 19.1.1 Issue 1.1, May 2021
DHCP Server
LAN
Switch
Router
Next-hop IP address
NE Installation Site
LCN1
1FINITY NE
LAN cable
173
Fujitsu and Fujitsu Customer Use Only