Table of Contents
Advertisement
Initial System Turn Up
Configure IP Connection to DCN
The following steps describe provisioning for one NE in detail. Remember this provisioning is required for each
NE involved in the network of OSC-linked NEs connecting the current NE (being turned up) with the DCN.
Step 1
Change to CLI configuration mode.
Command:
> configure
Configure NEM Interface
Step 2
Create the NEM interface and set its IP address.
Command:
% set interfaces interface ip-1/0/0/NEM type ip ipv4 forwarding true address
<ip_address> prefix-length <prefix-length> preferred true
Parameter
ip_address
prefix-length
Command Example:
% set interfaces interface ip-1/0/0/NEM type ip ipv4 forwarding true address
2.2.2.2 prefix-length 32 preferred true
Configure IP Interfaces for OSC Links
Prerequisite:
■ All provisioning for each OSC link is complete, including provisioning of the ETH interface on the E-SC-E1 port.
Step 3
Create an IP interface on the E-SC-E1 port that supports the OSC link. Configure this IP interface to share the
NEM IP address.
Command:
% set interfaces interface <interface> type ip ipv4 enabled forwarding true
address-src ip-1/0/0/NEM mtu <mtu_size>
Parameter
interface
·
Release 19.1.1
Issue 1.1, May 2021
Value
<1xx.xxx.xxx.xxx>
<0...32>
Value
<ip-<shelf>/0/0/E-SC-E1>
Description
IP address of the NEM interface
Length of the subnet prefix
Description
IP interface on the E-SC-E1 port that supports the OSC link
180
Fujitsu and Fujitsu Customer Use Only
Advertisement
Table of Contents
