Configure Ospf Routing - Fujitsu 1FINITY L100 User Manual

Initial System Turn Up

Configure OSPF Routing

5.5
Configure OSPF Routing
Step 1
Configure OSPF routing.
Command:
% set routing routing-instance <routing_instance_name> enabled routing-protocols
routing-protocol ospfv2 <protocol-instance-name> ospf instance
<routing_instance_name> ipv4 router-id <router-id> network <address> <mask> area
<area-id>
Parameter
routing_instance_name
protocol_instance_name
router-id
address
mask
area-id
Command Example:
% set routing routing-instance MCN enabled routing-protocols routing-protocol
ospfv2 OSC ospf instance MCN ipv4 router-id 1.x.x.xx network 1xx.x.x.x
2xx.xxx.xxx.x area 0.0.0.0
Step 2
Check the candidate configuration, if desired.
Command:
% show routing routing-instance
✓
This task is complete.
·
Release 19.1.1 Issue 1.1, May 2021
Value
<MCN>
<OSC>
<1xx.xxx.xxx.xxx>
<1xx.xxx.xxx.xxx>
<1xx.xxx.xxx.xxx>
<x.x.x.x>
Description
Name of routing instance
Name of routing protocol instance
OSPF router id per RFC 2328
IPv4 address, mask, and area ID defining the network on
which OSPF routing is enabled
Fujitsu and Fujitsu Customer Use Only
168